Investigating the performance of a solar still coupled with a semitransparent photovoltaic module under various wind speed conditions

Authors

1 Babol Noshirvani University of Technology

2 Prof., Sari Agricultural Sciences and Natural Resources University, Sari, Iran

Abstract

Clean electrical energy and freshwater are two basic human needs that can be met by using solar energy properly. In this article, the goal is to produce electricity and freshwater simultaneously by installing a solar still coupled with a semi-transparent solar module. The coupled solar system was simulated in ANSYS Workbench 2022 software environment.
To check the water yield, the system was simulated at different brackish water temperatures of 60 , 70 , and 80 and different wind speeds of 1, 2, 3, 4, and 5 m/s. Also, ten scenarios were defined and simulated according to radiation intensity and brackish water temperature. The results showed that the increase in brackish water temperature and the wind speed increased the amount of freshwater production, and the effect of brackish water temperature was greater compared to wind speed. By increasing the brackish water temperature from 60 to 70 and from 70 to 80 , the average water yield increment for the wind speed of 3 m/s is 64% and 120%, respectively. Also, by increasing the wind speed from 1 m/s to 5 m/s at 70 , the output power of the system increases by 10.53%. The simulation results in ten different scenarios showed that the coupled solar system was more efficient than the independent solar system in eight cases. According to the results of this research, it is suggested that the southern regions of the country with high radiation intensity and high wind speed should be considered for installing the coupled solar system.

Keywords

Main Subjects


[1] Dixit, Shivanshu. (2020) "Solar technologies and their implementations: A review." Materials Today: Proceedings 28: 2137-2148.
[2] Rahbar, Nader, and Javad Abolfazli Esfahani (2013) "Productivity estimation of a single-slope solar still: Theoretical and numerical analysis." Energy 49: 289-297.
[3] El-Agouz, S. A., Y. A. F. El-Samadony, and A. E. Kabeel (2015)"Performance evaluation of a continuous flow inclined solar still desalination system." Energy Conversion and Management 101: 606-615.
[4] Rahbar, Nader, Javad Abolfazli Esfahani, and Ehsan Fotouhi-Bafghi (2015) "Estimation of convective heat transfer coefficient and water-productivity in a tubular solar still–CFD simulation and theoretical analysis." Solar Energy 113: 313-323.
[5] Rashidi, Saman, Shima Akar, Masoud Bovand, and Rahmat Ellahi (2018) "Volume of fluid model to simulate the nanofluid flow and entropy generation in a single slope solar still." Renewable Energy 115: 400-410.
[6] Esfe, Mohammad Hemmat, and Davood Toghraie (2022) "Numerical study on the effect of solar radiation intensity on the fresh water productivity of solar still equipped with Thermoelectric Cooling System (TEC) for hot and dry areas of Semnan." Case Studies in Thermal Engineering 32: 101848.
[7] Esfe, Mohammad Hemmat, and Davood Toghraie. (2023) "Numerical investigation of wind velocity effects on evaporation rate of passive single-slope solar stills in Khuzestan province in Iran." Alex. Eng. J. 62: 145-156.
[8] Toosi, Seyed Sina Adibi, Hamid Reza Goshayeshi, and Saeed Zeinali Heris (2021)"Experimental investigation of stepped solar still with phase change material and external condenser." J. Energy Storage 40: 102681.
[9] Saleem, Khalid B., Kaouther Ghachem, Lounes Koufi, and Lioua Kolsi (2021) "Analysis of Double-diffusive natural convection in a solar distiller embedded with PCM and cooled with external water stream." J Tai. Inst. Chem. Eng. 126: 67-79.
[10] Raihananda, Faiz Akbar, Evan Philander, Alexander Fernando Lauvandy, Tubagus Ahmad Fauzi Soelaiman, Bentang Arief Budiman, Firman Bagja Juangsa, and Poetro Sambegoro (2021) "Low-cost floating solar still for developing countries: Prototyping and heat-mass transfer analysis." Results in Engineering 12: 100300.
[11] Nian, Yong-Le, Yan-Kai Huo, and Wen-Long Cheng (2021) "Study on annual performance of the solar still using shape-stabilized phase change materials with economic analysis." Solar Energy Materials and Solar Cells 230: 111263.
[12] Shoeibi, Shahin, Nader Rahbar, Ahad Abedini Esfahlani, and Hadi Kargarsharifabad (2021) "Improving the thermoelectric solar still performance by using nanofluids–Experimental study, thermodynamic modeling and energy matrices analysis." Sustainable Energy Technologies and Assessments 47: 101339.
[13] Serradj, DE Benhadji, T. N. Anderson, and R. J. Nates (2021) "The use of passive baffles to increase the yield of a single slope solar still." Solar Energy 226: 297-308.
[14] Rashidi, Saman, M. Bovand, and J. Abolfazli Esfahani (2016) "Optimization of partitioning inside a single slope solar still for performance improvement." Desalination 395: 79-91.
[15] El-Sebaii, A. A., M. R. I. Ramadan, S. Aboul-Enein, and M. El-Naggar (2015) "Effect of fin configuration parameters on single basin solar still performance." Desalination 365: 15-24.
[16] Rajaseenivasan, T., and K. Srithar (2016) "Performance investigation on solar still with circular and square fins in basin with CO2 mitigation and economic analysis." Desalination 380: 66-74.
[17] Mashaly, Ahmed F., A. A. Alazba, A. M. Al-Awaadh, and Mohamed A. Mattar (2015) "Predictive model for assessing and optimizing solar still performance using artificial neural network under hyper arid environment." Solar Energy 118: 41-58.
[18] El-Maghlany, Wael M (2015) "An approach to optimization of double slope solar still geometry for maximum collected solar energy." Alex. Engine. J. 54, no. 4: 823-828.
[19] Sahota, Lovedeep, and G. N. Tiwari (2017) "Analytical characteristic equation of nanofluid loaded active double slope solar still coupled with helically coiled heat exchanger." Energy Conversion and Management 135: 308-326.
[20] Arora, Swati, Harendra Pal Singh, Lovedeep Sahota, Manoj K. Arora, Ritik Arya, Sparsh Singh, Aayush Jain, and Arvind Singh (2020) "Performance and cost analysis of photovoltaic thermal (PVT)-compound parabolic concentrator (CPC) collector integrated solar still using CNT-water based nanofluids." Desalination 495 (2020): 114595.
[21] Isah, Abubakar Sadiq, Husna Bint Takaijudin, Balbir Singh Mahinder Singh, Syed Ihstam UI Haq Gilani, Khamaruzaman Wan Yusof, Abdurrasheed Sa'id Abdurrasheed, Tijani Oladoyin Abimbola, and Mujana Mohamad Shoeb (2022)"Solar energy desalination distillate yield and cost evolution, and statistical relationship between meteorological variables and distillate yield." Solar Energy 246: 256-272.
[22] Mazraeh, A. E., M. Babayan, M. Yari, Ali M. Sefidan, and Suvash C. Saha (2018) "Theoretical study on the performance of a solar still system integrated with PCM-PV module for sustainable water and power generation." Desalination 443: 184-197.
[23] Saini, Vineet, Lovedeep Sahota, V. K. Jain, and G. N. Tiwari (2019) "Performance and cost analysis of a modified built-in-passive condenser and semitransparent photovoltaic module integrated passive solar distillation system." J. enrg. Storage 24: 100809.
[24] Duan, Juan (2021) "A novel heat sink for cooling concentrator photovoltaic system using PCM-porous system." Applied Thermal Engineering 186: 116522.
[25] Maadi, Seyed Reza, Meysam Khatibi, Ehsan Ebrahimnia-Bajestan, and David Wood (2019) "Coupled thermal-optical numerical modeling of PV/T module–Combining CFD approach and two-band radiation DO model." Energy conversion and management 198: 111781.
 
[26] Mattei, Michel, Gilles Notton, Christian Cristofari, Marc Muselli, and Philippe Poggi (2006) "Calculation of the polycrystalline PV module temperature using a simple method of energy balance." Renewable energy 31, no. 4: 553-567
[27] Sampathkumar, K., T. V. Arjunan, P. Pitchandi, and P. Senthilkumar (2010) "Active solar distillation—A detailed review." Renewable and sustainable energy reviews 14, no. 6: 1503-1526.
[28] Dwivedi, V. K., and G. N. Tiwari (2009) "Comparison of internal heat transfer coefficients in passive solar stills by different thermal models: an experimental validation." Desalination 246, no. 1-3: 304-318.
[29] Shawaqfeh, Ahmad Taleb, and Mohammed Mehdi Farid (1995) "New development in the theory of heat and mass transfer in solar stills." Solar Energy 55, no. 6: 527-535.
[30] Emam, Mohamed, and Mahmoud Ahmed (2018) "Cooling concentrator photovoltaic systems using various configurations of phase-change material heat sinks." Energy conversion and management 158: 298-314.
[31] Tiwari, G. N., A. Minocha, P. B. Sharma, and M. Emran Khan (1997) "Simulation of convective mass transfer in a solar distillation process." Energy conversion and management 38, no. 8: 761-770.