Numerical Study of Thermo Hydraulic Effect of Wire Wrap Spacer with Different Pitch in Hexagonal Fuel Assembly

Authors

1 Nuclear Science and Technology Research Institute

2 Shahid Beheshti Univ

Abstract

In this paper, thermo-hydraulic effects of the wire-wrap spacer in a hexagonal fuel assembly with seven fuel rods have been investigated. The effects of wire-wrap pitch and Reynolds number on fluid flow, pressure drop, and temperature distribution have been analyzed. Thermal and fluid analysis has been studied for 66, 100, 200, and 400 wire-wrap pitches. K-ε turbulence model is used to perform this numerical simulation. The results are compared with a no-wire-wrap state. The results show that by increasing the Reynolds number, the pressure drop of the assembly with and without wire-wrap increases (100% increase in Reynolds number of 100,000). At a constant Reynolds number, decreasing the pitch of wire-wrap increases the pressure drop (60% increase by reducing the pitch from 200 to 100 mm). Wire-wrap improves flow mixing and heat transfer, and by reducing the pitch of the wire-wrap, the results have a more uniform distribution of temperature in each section of the assembly.

Keywords

References

[1] Todreas, N.E. and M.S. Kazimi,(2021) Nuclear systems volume I: Thermal hydraulic fundamentals.: CRC press.
]۲[ م. طالبی ، ع. حاتمی،(1400) تحلیل نیروهای ارتعاشی القایی غیردائم وارد بر یک مجتمع سوخت هسته ای در جریان محوری مغشوش. نشریه مهندسی و مدیریت انرژی.
]۳[ م. عسگری، م. طالبی، م. عبدی، (1392)شبیه سازی عددی افت فشار و انتقال حرارت اجباری حول میله های یک مجتمع سوخت هسته ای به همراه شبکه های نگه دارنده. مجله علوم و فنون هسته ای.
[4] Nijsing, R. and W. Eifler,(1974) A computation method for the steady state thermohydraulic analysis of fuel rod bundles with single phase cooling. Nucl Eng Des. 30(2): p. 145-185.
[5] Arwikar, K. and H. Fenech, (1979) Heat transfer, momentum losses and flow mixing in a 61-tube bundle with wire-wrap. Nucl Eng Des. 55(3): p. 403-417.
[6] Novendstern, E.(1972) Turbulent flow pressure drop model for fuel rod assemblies utilizing a helical wire-wrap spacer system. Nucl Eng Des. 22(1): p. 28-42.
[7] Fenech, H.,(1985) Local heat transfer and hot-spot factors in wire-wrap tube bundle. Nucl Eng Des, 88(3): p. 357-365.
[8] Shimizu, T., H. Ninokata, and H. Shishido,(1990) Distributed parameter analysis for the prediction of the fine structure of flow and temperature fields in wire-wrapped fuel pin bundle geometries. Nucl Eng Des, 120(2-3): p. 369-383.
[9] Lafay, J., B. Menant, and J. Barroil, (1975) Local pressure measurements and peripheral flow visualization in a water 19-rod bundle compared with FLICA II B calculations: influence of helical wire-wrap space system., CEA Centre d'Etudes Nucleaires de Grenoble.
[10] Gajapathy, R., et al.,(2007), CFD investigation of helical wire-wrapped 7-pin fuel bundle and the challenges in modeling full scale 217 pin bundle. Nucl Eng Des. 237(24): p. 2332-2342.
[11] Diller, P., N. Todreas, and P. Hejzlar, (2009) Thermal-hydraulic analysis for wire-wrapped PWR cores. Nucl Eng Des. 239(8): p. 1461-1470.
[12] Natesan, K., et al. (2010), Turbulent flow simulation in a wire-wrap rod bundle of an LMFBR. Nucl Eng Des, 2010. 240(5): p. 1063-1072.
[13] Rolfo, S., et al.,(2012) Thermal-hydraulic study of a wire spacer fuel assembly. Nucl Eng Des. 243: p. 251-262.
[14] Pacio, J., et al.,(2016) Experimental study of heavy-liquid metal (LBE) flow and heat transfer along a hexagonal 19-rod bundle with wire spacers. Nucl Eng Des. 301: p. 111-127.
[15] Cheng, S.-K. and N.E. (1986) Todreas, Hydrodynamic models and correlations for bare and wire-wrapped hexagonal rod bundles—bundle friction factors, subchannel friction factors and mixing parameters. Nucl Eng Des. 92(2): p. 227-251.
[16] Kazimi, M. and M. Carelli, (1976) Heat transfer correlation for analysis of CRBRP assemblies. Westinghouse Report.
[17] Wang, D., C. Peng, and Y. Guo, (2020) Thermal-hydraulic analysis of a 7-pin sodium-cooled fast reactor wire-wrapped fuel bundle. Int J Heat Mass Transf. 160: p. 120178.
[18] Lyu, K., et al.,(2021) Numerical investigation of thermal hydraulic behaviors in wire-wrapped bundle with smaller wire diameter of peripheral rods. Ann Nucl Energy. 163: p. 108526.
[19] Bovati, O., et al.,(2022) Pressure drop and flow characteristics in partially blocked wire wrapped rod bundles. Ann Nucl Energy, 165: p. 108671.
[20] Sreenivasulu, T. and B. Prasad, (2009) Flow and heat transfer characteristics in an annulus wrapped with a helical wire. Int J Therm Sci, 48(7): p. 1377-1391.
Journal of Solid and Fluid Mechanics
Volume 12, Issue 6
January and February 2023
Pages 205-217

Files

Share

How to cite

Statistics